Current Cost EnviR Guide de l'utilisateur télécharger pdf (Page 10)

EnviR - The SmartR Monitor

• A full cycle of history output can be initiated for download on demand by pressing and holding the

DOWN (V) and OK buttons together until the LED ashes. Please note: all processor activity is

halted during this download, even the clock, with a lot of history, the download may take some time!

Self-resets when done.



Your EnviR monitor should reach you in perfect condition. If you have connected it properly but cannot

get it to work, please check the following before contacting us for assistance.



• Do not attempt to repair or service any part of the EnviR equipment. Contact our customer service

department for assistance.

• Do not immerse the product in water, or any other liquids.

• Do not expose the product to heat, ame, steamy conditions or extreme cold.

• Do not open the equipment or touch any of its electronic circuitry.

• Do not hit, strike or drop the equipment—if the display gets broken, take special care not to

touch the liquid crystals.

• Do not use this product for any other purpose for which is was intended. If the equipment is used in a

mannernot specied by the manufacturer, the protection provided by the equipment may be impaired.

Changes or modications not expressly approved by the party responsible for Compliance could

void the User’s authority to operate the equipment.

  

No display Faulty display and/or display

power supply

Contact supplier

Corrupted display

(incomplete data)

Faulty display Contact supplier

Alternating readings Display picking up a signal from

a neighbours’ transmitter

Pair your transmitter and

display again, see page 5

Data does not change Incorrect installation Refer to page 7

Costs reading seems

excessively high or low

Correct tariff has not been set Refer to page 8 – Adjusting

your electricity price

Temperature gauge

excessively high

Display too close to heat source Choose a different location

PowerSave Envi R Man.indd 10 04/11/2011 14:47

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

Current Cost EnviR Guide de l'utilisateur Page 10